This seat is large enough for two,
but you can make it a single seat, or make it longer by adding additional supports and longer slats.
YOU WILL NEED:
1 of 900 x 900mm 16mm marine plywood*
7 of 20 x 94mm PAR pine – cut to 1040mm length
12 of 20 x 69mm PAR pine
– 3 cut to 1000mm length
– 9 cut to 1040mm length
5 x 50mm cut screws
Wood glue
Wood filler (tinted for finished colour)
Exterior sealer
Mineral turpentine
Rags
TOOLS:
Drill / Driver plus assorted bits
Jigsaw and clean-cut blade
Orbital sander plus 60-, 120- and 240-grit sanding pads
Paintbrush
Tape measure and pencil