How to Faux Marble Microwave With Contact Paper?

STEP 3: Cut away the excess Use an X-acto knife to cut any excess away from the edges of the microwave, giving it a nice clean line.

STEP 4: Cut out the vent area Most microwaves have vents

on the side and they can’t be covered, so you will have to cut away the contact paper that is covering each of these holes. This is a time consumer, but also kind of satisfying… then again, I love tedious tasks sometimes, soooo to each their own hehe.

STEP 5: Cover the front part Now that the large portion

of the microwave is covered it is time to move onto the door. My husband liked it with the front being silver, but I wound up covering the whole thing to see what it would look like. First use a small piece to cover the side portion with the buttons. (Your microwave may be different, so this part may have to be completed differently, but it should still use the same techniques) For the corners, cut a small slit from the tip of the corner out. Fold one flap in and then the other over top. Cut any excess away from the outer edges as you did for the body of the microwave.

STEP 6: Cut away the button part Obviously you will

need to uncover the buttons, so carefully cut away the contact paper that is covering this area with your X-acto knife.

STEP 7: Measure and cover the door The only thing left to cover is the door! First place a large piece over the front starting at the top and allowing enough clearance for the top to be folded over the top ledge of the door. Now cut directly above and beneath the handle so that you are simply covering the outer trim that surrounds the door. Cut out the majority of the window space as well.

For the corners, use the same technique you did for the front flap in after the other.

At this point cut the outer edge away as well and fold all edges over so that all the trim is covered.

STEP 8: Make sure everything in covered As you can see in the picture above there is still a small strip that is uncovered. Take a small strip and place it so that it lines up evenly with the upper and bottom rims edges and blends nicely. Fold it around the edge smoothing out bubbles as you go. Trim away any excess.

STEP 9: Trim away the rough edges Now take your X-acto knife and trim away any rough edges so that the window is completely clear and cleanly outlined. I left a bit of the stainless steel showing because it was curved and the contact paper didn’t stick well, plus it looked like an accent edge, so I thought it looked nice uncovered. I also didn’t cover the handle as I felt that it would look chunky and awkward.

I honestly didn’t know if this would look good at all, but I kinda think it is fun! It is a great way to add a fun piece to your kitchen, plus it isn’t permanent, so if you hate it you can take it right off!

If only they made real marble microwaves! This makes me want one haha… not that I use my microwave much, but it would still be fun. I know some people may get worried about heat, but honestly people cover their ovens with contact paper and those get much warmer than microwaves. Not to mention I tested mine first and the sides don’t get hot. Plus uncovering the vents allows it to operate as normal. I used it afterward just to see, and everything was fine!

Want more details about this and other DIY projects? Check out my blog post! GO